with Full Power Off And Overcharge Protection, Featuring an LCD Display
- Features an LCD display that shows charging status and operational information during use.
- Provides a full power off function to shut down the module when not in use.
- Designed for operation with voltages up to 36V, compatible with various batteries within this range.
-
Battery Pack Type: Lithium-ion
-
Power Supply: Hard-Wired
-
Acceptable Voltage Range: Below 50 V
Key Features:
Supports Lead-acid/Gel/Lithium Batteries with a voltage range of 6V to 60V. It can simultaneously display voltage, battery percentage, and charging duration on an LCD screen. The functionality is robust, enabling automatic charge control and management of charging time, with the ability to configure and upload relevant parameters via a serial port.
Parameter Configuration:
a) Long press the SET button to access the settings menu.
b) Cycle through the parameters you wish to adjust by briefly pressing the SET button.
c) Once the parameters are chosen, you can adjust them using the UP/DOWN keys for both short and long presses (to quickly increase or decrease values). To configure additional parameters, go through steps b and c again. After all parameters have been configured, press and hold the set key to exit and save your settings.
The Key Function: In the Run interface (main screen): A short press of the SET button will show the currently set parameters, while a short press of the UP button will switch between displaying the charge percentage and the charging duration.
Quickly press the DOWN button to choose the option to enable or disable the relay. If the relay can be activated, it will display 'off' as a notification. Press and hold the UP button to toggle the low power mode. When ON, the backlight will turn off after 10 minutes of inactivity. When OFF, the backlight remains constantly lit. Press and hold the SET button to access the parameter settings.
Extra Functionality:
a) Function for recording charging duration: If charging time control is not activated, the device will log the total time. When the time display interface is accessed, the charging duration will blink, and it will exit to the time display interface or activate the next charge (relay conduction) when it is empty.
b) Automatic parameter verification: Once the parameters are configured and exited, if volt-LI dn is greater than or equal to volt-HI UP, the system will flash 'ERR' as a notification.
c) Battery access detection: This device is connected to the battery; if it is not connected, the system will display 'NbE' in the downlink as a notification.
Package contains:
1 * XY-L30A Battery Charging Control Module.
